Fastway handgaurds (Used) for BETA (Xtrainer, 250RR, 300RR)

[MuddySully]

Selling my Fastway Version 2 handguards which I bought directly from ProMoto Billet (US) in May 2016. I had just bought my Xtrainer new and wanted to try them out for my new bike.

I paid about £150+ for them and would be happy to see them go to a new home for £40.

Selling them because I found that they sit quite high in comparison to the levers, however this has never caused any problems with damage to the levers. I have attempted to correct this by putting a small additional bend in them as per the seller’s instructions.

The handguards will fit most of the BETA enduro range including the 250 and 300RR two strokes.

Version 2 are the one piece ultra strong center clamp, with integrated hand guard mount tabs, that gives a rigid and clean mounting system.
Below is the link to the web site that shows item. (FIT HANDGUARD V2 1-1/8" BAR 90/41 - 22-V2-905)
https://fastwayperformance.com/hand-gua ... 2-974.html

There is the inevitable scuffing on the edges, but nothing major as all my off’s have been at low speed and on the trails.

Please reply to this post or PM me if you are interested or have any questions.
I am going to the Club night on the 24th of January so could bring them along, or I live in Haslemere if you want to take a look.

Peter

[mudeevee]

Hi Peter,
I'll take em! Thank you.

Exchange at club night if that's ok?

Tx

Derek

[MuddySully]

Thanks Derek, I'll bring them along.
Peter